Steam Shower Installation in Atlanta
Steam showers done right: vapor-proofing, slope, and a generator sized to the room.
The most common problem I see on repair calls? Steam showers built like regular showers. One gap in the vapor envelope and you've got mold behind the drywall. I strip bathrooms to the studs, seal them properly, slope the ceiling, and size the generator to the room — so the steam fills fast and the walls stay dry.
What You're Getting
SPEC SHEETVapor-Tight Waterproofing
Steam pushes moisture where standing water can't go. I seal the enclosure with liquid waterproofing membranes so vapor never reaches your framing.
Generator Sized to the Room
I size the generator to your cubic footage, ceiling height, and wall material. Too small and the steam never fills; too big and you trip the breaker.
Sloped Ceiling, No Dripping
A flat ceiling rains hot droplets on you. I frame the ceiling with a proper slope so condensation runs down the walls.
Real Controls
Digital keypad, auto-flush, aromatherapy pump — the options that are actually worth it, and the ones that aren't.
Code-Compliant 240V
Steam generators need dedicated 30–50 amp circuits. I handle the permitting and the inspection across metro Atlanta.
Tile That Holds Up
Epoxy grout, not cement grout. Cement grout absorbs moisture and grows mold — epoxy doesn't.
How the Install Goes
Phase 1: I Check the Bathroom
I inspect the framing, the panel (30–50 amps needed), and the plumbing. Then I tell you what's possible.
Phase 2: Strip & Seal
Down to the studs. Insulation in, then a continuous vapor barrier — the single most important step, and the one most contractors skip.
Phase 3: Generator & Plumbing
Copper steam lines (never PEX), generator tucked in an accessible spot, digital controls pre-wired.
Phase 4: Slope & Waterproof
Ceiling slope framed, then multiple coats of liquid membrane on every surface, joints taped.
Phase 5: Tile & Grout
Tile set with epoxy grout. No porous cement grout — that's what grows mold.
Phase 6: Fire It Up
Full-capacity steam test, heat check, and I walk you through the controls.
Installation Gallery
"We were worried about mold. Grayson sloped the ceiling, sealed everything, and the steam fills the room in minutes. No drips, no damp smell."
Proudly Serving Metro Atlanta
From Buckhead to Marietta, Alpharetta to Decatur — I design and build custom saunas across the greater Atlanta area.
Atlanta • Buckhead • Midtown • Alpharetta • Marietta • Decatur • Roswell • Sandy Springs • Dunwoody • Brookhaven • Smyrna • Kennesaw • Acworth • Woodstock • Canton
I've built 500+ saunas in metro Atlanta. Tell me about your space.
Tell me about your bathroom. I'll give you a straight number — free.
Licensed & Insured · 20+ Years · 500+ Projects